Compound crown molding angles, cut flat.
Miter
31.6°
Bevel
33.9°
Lay the molding flat on the saw table (upside-down and backwards — ceiling edge against the fence, wall edge down). Cut a test piece before your final cut.
Miter and bevel in half-degree steps around your entered corner angle, at your selected spring angle. Shaded rows mark whole degrees:
| Wall | Miter | Bevel |
|---|
Rooms
Cut list
Left End Joint Type
Piece Length (in inches)
Enter values as decimals (e.g. 96.75, not 96 3/4). Converting a feet-and-inches measurement? Use the converter.
Right End Joint Type
No pieces added yet.
Convert a feet-and-inches reading into the decimal value this app uses, without doing the fraction math by hand.
= 0 in